shopoberlin

You will find below a complete analysis of the rules of the game of Backgammon. Whether you’re a seasoned expert or a novice, you will certainly find this information very useful. Feel free to browse through this section Backgammon for more information on strategy, tips, odds, bonuses, etc..

The configuration of the game

1. Backgammon is played by two players face each other in a deck (board game), composed of two sets of 12 “arrows”.

2. The movement of pawns is decided by two dice thrown from a cup to ensure the chance.

3. Before you begin a game, each player may request to throw the dice for the choice of squares and pawns.

4. The parties are relatively short and usually played from a fixed number of games to win (for example, the first player to win three out of five parties is declared the winner).

5. A typical game of backgammon is played with the following configuration. But keep in mind that there are many variants of this game

Roll the dice

1. At any time during the game, the player may ask to mix the dice. Four dice are placed in a beaker and discarded. The opponent selects a die, then the pitcher as well, and again the opponent and then the pitcher, who captured the last die.

2. For the first roll, each player rolls a single die. The player who draws the highest number is the first to play. If the dice have equal values, each player must raise his die before a winner is declared. After the first throw of the dice players roll the dice and move their pawns in turn.

3. The die must be perfectly flat once launched. If one of the two dice is “broken”, it must be restarted.

4. The die must be perfectly motionless before a player can touch them. They can not be launched before the opponent has finished his turn. The dice must be restarted if these rules are not followed.

5. The round is over when the player takes over the dice. If he does so without having used all his numbers, the enemy should be forced to do it or go ahead and play. A player who picks up his dice can not get them back on the table to finish his round.

The movement of pawns

1. The movement of pieces can be realized as follows:

o Play one or more pieces according to figures from each die. For example, if the numbers 5 and 3 out, the player can move first piece of 5 “arrows” and another 3. A pawn can be moved twice, but each movement is independent of the other, that is to say, in our example, the pawn can be moved from 5 to a “boom” available (look at rule No. 3 on the movement of pawns) and then 3 more. But the order of movement is not fixed: the player can decide to move the first pin 3 then 5 then.

o Enter a pawn that has been touched by the opponent (see the rule number 3 on the movement of pieces) of the bar to an open point on the area of the opponent, by any number of dice .

o Remove a pawn in the opponent’s table, but only once all the pieces are in this area.

2. If the dice roll gives a double, the player must play each die twice. For example, if the player draws two 6, it must move his checkers a total of 24 boxes (6 X 2) + (6 X 2) = 24.

3. A player can move his pawn on an arrow when there is no pawn, pawns to where it is already present or on a triangle occupied by a single checker of the opponent. This movement is called “strike” (or attack). The piece that has just been attacked is then returned to the bar, where it will be reintroduced into play later. A player can not move his pawn to a point where two opposing pieces, or more. It is impossible to have all the pieces on the same point simultaneously.

4. A pawn which has been attacked and placed in the bar can not enter the area of the opponent in that the player draws a number that allows it to take place on an open arrow. If a player has more than a pawn in his bar, he can not move other pieces until all pieces of the bar is taken back in.

5. Once all the pieces of a player are placed in the area, he can begin to remove them from the table to get them out. This can be achieved as follows:

o Once the player is in a position to bear off, he may do so by the value shown by a die, or from an occupied point whose value is less than the specified number. Thus, a 5 can be used to remove a checker on a point 4 only if there are no pieces occupying the point 5 and point 6.

o If the dice shows the number of empty triangle, no pawn can be released if there are pawns on a higher point. For example, if a player shoots a 3, it should move any piece occupying the points 4, 5 or 6, rather than leaving a pawn items 1 or 2.

o You are not obliged to bear off if you can move another pawn forward from another point.

In case of failure of a player

1. When an error occurs, it must be corrected if one player realizes it before the next game round starts.

2. If a player makes a movement error, the other must let him know and correct the error before the dice are thrown again, not after.

Score

1. A game is won when one player manages to get his checkers before his opponent.

2. If one player wins and his opponent is able to escape any checkers, the player gains winners are doubled: this is called a gammon.

3. If one player wins, while his opponent has managed to get any checkers, and one or more of their pieces are still in the winner’s table or in the bar, the gains of winning are tripled: is backgammon!

4. To increase the speed and risk a doubling cube (doubling cube) is often used. Prior to launch, if a player believes that his position is superior to that of his opponent, he may decide to double the lead in. This famous die is positioned so that 2 are highlighted to indicate that the game is to be doubled.

The opponent has a choice to accept this offer, and continue the game with a formulation doubled, or refuse and give up. If the player accepts the double, it is now in possession of the die and reserves the right to double again at any time during the game, before throwing the dice. While on the die appear only the numbers 2, 4, 8, 16, 32, and 64 enrolled, the possibility of doubling is, in principle, without limit.